Chapter 8: Troubleshooting With Remote Packet Capture - Avaya WLAN 8100 Series Troubleshooting Manual

11. Use the command show wireless ap radio TSpec-statusto display
12. Use the command show wireless client tspec-status to display the

Chapter 8: Troubleshooting with remote packet capture

Use the following parameters and commands to troubleshoot using the remote packet
capture.
Configuring a capture profile
Use the following parameters to define a capture profile on a managed Access Point (AP).
Capture profile name
Capture interfaces
Interface group
All ( Both Radios)
2.4 GHz only
5.0 GHz only
Promiscuous Mode
Filter on SSID
Filter on MAC
Avaya WLAN 8100 Troubleshooting Guide
Available Admission Capacity on a per User Priority or per Access Category basis
information in Beacon and Probe Response messages.
current TSPEC inactivity level.
Troubleshooting with remote packet capture
Specify the interfaces on which the packet capture
is applied. In the current release, the administrator
can specify 2.4GHz or 5GHz radio, or both. The
administrator uses codes to select the interface(s).
Selection code
0x00
0x01
0x02
Enable/Disable: when promiscuous mode is
disabled, only traffic directed to the AP is captured.
Note that enabling promiscuous mode can result in
multiple AP(s) reporting copies of same packets.
Traffic is captured only on specified SSID. To
exclude filtering on SSID, set this value to empty
string. This setting is ignored in promiscuous
mode.
Traffic is captured only from/to specific wireless
client MAC address. To exclude this filter set the
value to empty string. This setting is ignored in
promiscuous mode. This filter is not applicable to
beacons.
August 2011 53