Mitsubishi Electric MELSEC-L SSCNETIII/H User Manual page 43

Do not slide modules from the edge of the DIN rail when mounting them. Doing so may damage the metal part located on the
back of the module.
(2) Removal procedure
Remove the modules from the DIN rail by reversing the above procedure.
(3) Applicable DIN rail model (IEC 60715)
• TH35-7.5Fe
• TH35-7.5Al
• TH35-15Fe
(4) DIN rail stopper
Use a stopper that is attachable to the DIN rail.
(5) Interval between DIN rail mounting screws
To ensure the strength of a DIN rail, tighten DIN rail mounting screws (obtained by user) within 30mm away from
the both edges of the DIN rail and at 200mm-interval between the screws.
DIN rail
35mm
30mm
or less
P P
CHAPTER 6 INSTALLATION AND WIRING
DIN rail mounting screw
(obtained by user)
30mm
P
or less
P=200mm or less
6
41