Idling Adjustment; Drive Chain Replacement; Drive Chain Cutter - Honda XLR200R Service Manual

CHECKING AND ADJUSTMENT
Check the condition of O-ring of timing hole cap and crankshaft
hole .cap, if damaged replace with new ones .. Apply engine oil
to timing hole cap and crackshafthole caP, then attach.
Torque : Timing Hole Cap :.0.6 kg-m
: Crankshaft Hole Cap : 0:8 kg-m
Install by reversing removal procedure
IDLING ADJUSTMENT
• Idling adjustment should be done· atter warming up the
engine
" After carburetor overhaul, adjust Idling after pilot screw
adjustment.
Put side stand up and make slire the vehicle is supported
adequately.
Put
in
neutral gear, start on warm l,Ip.
Turn throttle stop screw and adjust idling.
Idling rpm: 1,400± 100rpm
DRIVE CHAIN
Replacement
• The drive chain uses master link joint pin type. When
repmcing cnain, use soecialized tools and replacement
chain.
t
Never use clip
type
chain.
• Drive chain is of the enoless type. Use chain cutter when
replacing.
• When abnormality-
is,
seen in .drive chain, check sprocket.
as well.. If there is abnormality in sprocket, replace b()th.
Loosen drive chain assemble tools.
Drive Chain Cutter 07HMH-MR1 01 02
Befor~
using any o'f the specialized tools, makes!lre you
read the instructions manuals.
3-12
Tim.ng Hole Cap/D-ring
Crankshaft Hole Cap/O-rlng
Throttle Stop Screw
Drive Chain (.;utter