3.
Install the blade holder.
Insert until the
collar is flush with
the surface.
Screw
Close the front cover, then press
Important Note on the Handling and Use of the Cutting Carriage
Leave the cutting-carriage screw loose when no blade holder is installed. Keeping the screw tightened causes the
blade-holder insertion hole to become gradually smaller, making installation difficult.
Screw
Loosen the screw shown in the figure.
Support the screw from below and insert the blade holder.
If installed without supporting the screw in this way, cutting quality
may become poor.
Screw
Support it from below.
Tighten the screw.
Tug the blade holder upward to make sure it does not come loose.
.
6. Install the Blade
41