Network Settings; Introduction; Step 1 : Make The Nework Settings For The Computer - Roland SOLJET Pro III XC-540 Setup Manual

7. Network Settings

Introduction

This machine has a built-in print server as a network interface. When you use the print server, you can send output
data to the machine from anywhere on the network. TCP/IP is used as the protocol. Make sure the machine is con-
nected to the network by an Ethernet cable.
The network settings on the machine must be made manually, using the operation panel. For information about how
to make the settings, refer to "Step 2: Make the Network Settings on the Printer" later in this chapter.
Also, to perform output from the machine, the software raster image processor (RIP) packed with the machine must be
installed and set up on the computer you're using. For information about installation and setup, refer to the documen-
tation for the software RIP.
Important !
The examples used in the procedures for making the settings described in this section assume you are using one
computer and one machine. The procedures and setting values described here may not be suitable for all operat-
ing environments.
If the computer you're using is connected to a number of networked devices or to the Internet, incorrect settings
may adversely affect the entire network. For detailed information about the settings, consult your network admin-
istrator.
Also, the addresses used in this section are merely example settings.

Step 1 : Make the Nework Settings for the Computer

Procedure
–
Log on to Windows as a member of the "Administrators" group.
—
For Windows XP:
From the [Start] menu, click [Control Panel]. Click [Network and Internet Connections], then click
[Network Connections].
For Windows 2000:
From the [Start] menu, click [Settings], then click [Network and Dial-up Connections].
˜
42
Double-click the [Local Area Connections] icon. Click
[Properties].