Table of Contents
Advertisement
Vector Solo 65kV Applicator - Safety
AREA
Tells where hazards
may occur.
Spray Area
AH-08-02.6
HAZARD
Tells what the hazard is.
Fire Hazard
Improper or inadequate oper-
ation and maintenance proce-
dures will cause a fire hazard.
Protection against inadvertent
arcing that is capable of causing
fire or explosion is lost if any
safety interlocks are disabled
during operation. Frequent pow-
er supply shutdown indicates a
problem in the system requiring
correction.
SAFEGUARDS
Tells how to avoid the hazard.
Fire extinguishing equipment must be present in
the spray area and tested periodically.
Spray areas must be kept clean to prevent the
accumulation of combustible residues.
Smoking must never be allowed in the spray area.
The high voltage supplied to the atomizer must be
turned off prior to cleaning, flushing or maintenance.
When using solvents for cleaning:
Those used for equipment flushing should have
flash points equal to or higher than those of the
coating material.
Those solvents used for cleaning must have a
flash point at minimum of 5°C (9°F) greater than
the ambient temperature. It is the end users re-
sponsibility to insure this condition is met.
Spray booth ventilation must be kept at the rates
required by local and/or country codes. In addition,
ventilation must be maintained during cleaning op-
erations using flammable or combustible solvents.
Electrostatic arcing must be prevented.
Test only in areas free of combustible material.
Testing may require high voltage to be on, but only
as instructed.
Non-factory replacement parts or unauthorized
equipment modifications may cause fire or injury.
If used, the key switch bypass is intended for use
only during setup operations. Production should
never be done with safety interlocks disabled.
The paint process and equipment should be set
up and operated in accordance with local and/or
country safety codes.
Ransburg
2
Advertisement
Table of Contents
