Verifying The Configuration - Cisco catalyst 6500 series Configuration Note

Configuring SLB Modes

Verifying the Configuration

To confirm that your configuration is working properly, use these commands in the RP mode:
Cat6k# show ip slb mode
Cat6k# configure terminal
Enter configuration commands, one per line.
Catk6-1(config)# ip slb ?
dfp
entries
firewallfarm
mode
natpool
probe
serverfarm
vserver
To confirm that you configuration is working properly, use these commands in the Cisco IOS SLB mode:
Cat6k(config)# module csm 5
Cat6k(config-module-csm)# ?
SLB CSM module config
default
dfp
exit
ft
map
natpool
no
policy
probe
serverfarm
static
sticky
vlan
vserver
To confirm that a single CSM in the chassis configuration is working properly, use these commands in
the CSM mode:
Cat6k# show ip slb mode
Catk6-1# configure terminal
Enter configuration commands, one per line.
Cat6k(config)# ip slb ?
dfp
ft
map
mode
natpool
policy
probe
serverfarm
static
sticky
vlan
vserver
Catalyst 6500 Series Content Switching Module Configuration Note
3-8
SLB configured mode = rp
configure Dynamic Feedback Protocol manager
initial and maximum SLB entries
configure an SLB firewall farm
configure SLB system mode
define client nat pool
configure an SLB probe
configure an SLB server farm
configure an SLB virtual server
Set a command to its defaults
configure Dynamic Feedback Protocol manager
exit SLB CSM module submode
configure CSM fault tolerance (ft) feature
configure an SLB map
configure client nat pool
Negate a command or set its defaults
configure an SLB policy
configure an SLB probe
configure an SLB server farm
configure static NAT for server initiated connections
configure a sticky group
configure a vlan
configure an SLB virtual server
SLB configured mode = csm
configure Dynamic Feedback Protocol manager
configure CSM fault tolerance (ft) feature
configure an SLB map
configure SLB system mode
configure client nat pool
configure an SLB policy
configure an SLB probe
configure an SLB server farm
configure static NAT for server initiated connections
configure a sticky group
configure a vlan
configure an SLB virtual server
End with CNTL/Z.
End with CNTL/Z.
Chapter 3 Getting Started
OL-4612-01