Cisco catalyst 6500 series Configuration Note page 30

Configuring Modes for Networking
Figure 2-1
Client
workstation
The addresses in
Note
You configure single subnet (bridge) mode by assigning the same IP address to the CSM client and server
Note
VLANs.
To configure content switching for the single subnet (bridge) mode, perform this task:
Command
Step 1
Router(config-module-csm)# vlan
database
Step 2
Router(vlan)# vlan 2
Step 3
Router(vlan)# vlan 3
Step 4
Router(vlan)# exit
Step 5
Router(config-module-csm)# vlan 2
client
Step 6
Router(config-slb-vlan-client)# ip
addr 192.158.38.10 255.255.255.0
Step 7
Router(config-slb-vlan-client)#
gateway 192.158.38.20
Step 8
Router(config-slb-vlan-client)#
gateway 192.158.38.21
Catalyst 6500 Series Content Switching Module Configuration Note
2-2
Single Subnet (Bridge) Mode Configuration
Gateway
192.158.38.20
Router A
NAS
router
Router B
Gateway
192.158.38.21
Figure 2-1 refer to the steps in the following task table.
Chapter 2 Networking with the Content Switching Module
Content Switching Module
Client-side Server-side
192.158.38.10 192.158.39.10
Virtual server 1
192.158.38.30
VLAN 2
Content provider
Server A
Purpose
1
Enters the VLAN mode .
Configures a client-side VLAN
Configures a server-side VLAN.
Exits the mode for the configuration to take effect.
Creates the client-side VLAN 2 and enters the SLB
1
VLAN mode .
Assigns the CSM IP address on VLAN 2.
Defines the client-side VLAN gateway to Router A.
Defines the client-side VLAN gateway to Router B.
VLAN 3
Server B
Server Farm 1
2
.
OL-4612-01