Vlan Mode - Cisco catalyst 6500 series Configuration Note

Chapter 2 Networking with the Content Switching Module
Command
Step 9
Router(config-slb-vserver)# vlan 3
server
Step 10
Router(config-slb-vlan-client)# ip
addr 192.158.38.10 255.255.255.0
Step 11
Router(config-slb-vlan-client)# exit
Step 12
Router(config-module-csm)# vserver
VIP1
Step 13
Router(config-slb-vserver)# virtual
192.158.38.30 tcp www
Step 14
Router(config-slb-vserver)# serverfarm
farm1
Step 15
Router(config-module-csm)# inservice
1. Enter the exit command to leave a mode or submode. Enter the end command to return to the menu's top level.
2. The no form of this command restores the defaults.
3. This step assumes that the server farm has already been configured. (See the
page
Note Set the server's default routes to Router A's gateway (192.158.38.20) or Router B's gateway
(192.158.38.21).
OL-4612-01
5-1.)
Purpose
Creates the server-side VLAN 3 and enters the SLB

VLAN mode.

Assigns the CSM IP address on VLAN 3.
Exits the submode.
Creates a virtual server and enters the SLB virtual server
mode.
Creates a virtual IP address.
Associates the virtual server with the server farm
Enables the server.
Catalyst 6500 Series Content Switching Module Configuration Note
Configuring Modes for Networking
"Configuring Server Farms" section on
3
.
2-3