Configuring Csm B (Regular Firewall Example) - Cisco catalyst 6500 series Configuration Note

Content switching module
Hide thumbs Also See for catalyst 6500 series:
Table of Contents

Advertisement

Chapter 11
Configuring Firewall Load Balancing

Configuring CSM B (Regular Firewall Example)

To create the regular configuration example, perform the following configuration tasks for CSM B:
Note
Although the configuration tasks are the same for both CSM A and CSM B, the steps, commands, and
parameters that you enter are different.
Creating VLANs on Switch B
Note
This example assumes that the CSMs are in separate Catalyst 6500 series switch chassis. If they are in
the same chassis, all of the VLANs can be created on the same Catalyst 6500 series switch console.
To create three VLANs on Switch B, perform this task:
Command
Step 1
Switch-B(config)# vlan
Step 2
Switch-B(vlan)# vlan 201
Step 3
Switch-B(vlan)# vlan 200
Step 4
Switch-B(vlan)# vlan 20
1.
2.
3.
4.
Configuring VLANs on CSM B
To configure the three VLANs on CSM B, perform this task:
Command
Step 1
Switch-B(config)# module csm 6
Step 2
Switch-B(config-module-csm)# vlan 201
server
Step 3
Switch-B(config-slb-vlan-server)# ip
address 200.0.0.26 255.255.255.0
Step 4
Switch-B(config-slb-vlan-server)# alias
200.0.0.20 255.255.255.0
Step 5
Switch-B(config-slb-vlan-server)# exit
OL-4612-01
Creating VLANs on Switch B, page 11-21
Configuring VLANs on CSM B, page 11-21
Configuring Server Farms on CSM B, page 11-22
Configuring Virtual Servers on CSM B, page 11-23
Do this step on the switch console of the switch that contains CSM B.
VLAN 201 provides the connection to the secure side of the firewalls.
VLAN 20 provides the connection to the internal server farms.
VLAN 200 provides the connection to the internal network.
Purpose
Enters the VLAN mode
Creates VLAN 201
Creates VLAN 200
Creates VLAN 20
Purpose
Enters multiple module configuration mode and
specifies that CSM B is installed in slot 6.
Specifies VLAN 201 as the VLAN that is being
configured, identifies it as a server VLAN, and
enters VLAN configuration mode.
Specifies an IP address and netmask for VLAN 201.
Specifies an alias IP address and netmask for
1
VLAN 201
.
Returns to VLAN configuration mode.
Catalyst 6500 Series Content Switching Module Configuration Note
Configuring Regular Firewall Load Balancing
1
.
2
.
3
.
4
.
11-21

Advertisement

Table of Contents
loading

This manual is also suitable for:

Catalyst 6000 series

Table of Contents