Cisco catalyst 6500 series Configuration Note page 83

Chapter 7 Configuring Redundant Connections
Figure 7-1
Client
workstation
The addresses in
Note
To configure the active (A) CSM for fault tolerance, perform this task:
Command
Step 1
Router(config-module-csm)# vlan 2 client
Step 2
Router(config-slb-vlan-client)# ip addr
192.158.38.10 255.255.255.0
Step 3
Router(config-slb-vlan-client)# gateway
192.158.38.20
Step 4
Router(config-module-csm)# vserver vip1
OL-4612-01
Fault-Tolerant Configuration
Gateway
192.158.38.20
Router A
NAS
router
HSRP
Router B
Gateway
192.158.38.20
Figure 7-1 refer to the steps in the following two task tables.
Catalyst 6500 Series Content Switching Module Configuration Note
Content Switching Module
Client-side Server-side
Virtual server 1
A
192.158.38.10
VLAN 9
VLAN 2
IP
address
192.158.38.40
Virtual server 1
B
Content Switching Module
Purpose
Creates the client-side VLAN 2 and enters the SLB
1
VLAN mode .
Assigns the content switching IP address on
VLAN 2.
(Optional) Defines the client-side VLAN gateway
for an HSRP-enabled gateway.
Creates a virtual server and enters the SLB vserver
mode.
Configuring Fault Tolerance
Alias IP adress
(default gateway)
192.158.39.20
Server A
192.158.39.10
192.158.39.30
Server B
Alias IP adress
(default gateway)
192.158.39.20
7-3