Output Span (A, B) - Symmetricom TimeSource 2700 Manual

S S S S S S S S

Output Span (A, B)

Shelf Front Panel
Connect the T1 outputs to the two RJ45 connectors labeled
Output Span A and Span B. Figure 8 shows the location of the
connectors on the front panel, and Table E lists the pinouts of
each connector (Output Span A and Span B).
Note:
Grounding the shield at both ends is not recommended.
Table E. Front Panel T1 Output Connector Pinouts
S S S S S S S S
The shield is normally grounded only at the signal source.
Pin
4 Ring
5 Tip
7 Frame ground
8 Frame ground
Note: Pins not listed are reserved
for future use. Use category 5 EIA/
TIA 568 A or B compliant cable.
S S S S S S S S
Signal Name
S S S S S S S S
45
Installation
S
3
3
4
5