Symmetricom TimeSource 2700 Manual page 33

S S S S S S S S
Procedure A. High-Gain Antenna Mounting
Step
1 Assemble the antenna and mounting bracket as follows:
a. Slide the N connector end of the antenna through the double D shaped hole in the bracket.
b. Slide the washer over the N connector, and position against the bracket.
c. Screw the nut over the N connector, onto the assembly.
2 Position the antenna bracket assembly against the front of the cable runway, with the
double D shaped hole pointing away from the cable runway.
3 From the rear of the runway, position the clamp around the runway, and slide the clamp through
the bracket slot and top hole.
4 Slide the two washers on the clamp, and position against the bracket.
5 Screw the two nuts on the clamp, and attach.
6 Attach the N end of the antenna cable to the antenna.
7 Route the antenna cable to the rear of where the TimeSource 2700 Shelf will be located,
and out of the way of traffic. Use tie-wraps or equivalent to dress the cable in accordance
with office procedures.
Note:
During that procedure, the strength of the CDMA signal will be
measured. Based on that measurement, the location of the
antenna may have to be changed to improve the signal strength.
S S S S S S S S
At the end of this chapter, there is a power-up procedure.
S S S S S S S S
Action
S S S S S S S S
33
Installation
S
3
3
4
5