Table of Contents
Advertisement
d
Warning!
Risk of accident when using the garage door
opener if persons, animals or objects are
within the range of movement of the equip-
ment that is being operated.
f When using the garage door opener, ensure
that no persons, animals or objects are within
the range of movement of the equipment that
is being operated.
f Observe the safety notes for the original hand-
held transmitter.
Notes on operation
f Always use the garage door opener in the
direction of travel.
Otherwise, range restrictions cannot be ruled
out.
f Before selling the vehicle, delete the
programmed signals of the garage door
opener on the keypad.
f Please read the instructions for the original
hand-held transmitter to find out whether the
original transmitter is equipped with fixed or
changeable code.
Deleting programmed signals
from the keys
This process deletes the standard codes set at
the factory. Do not repeat this process if you
would like to assign additional signals to the keys.
f Keep the two outer buttons of keypad A
depressed for approximately 20 seconds until
light-emitting diode B begins to flash.
Assigning garage door opener signal
to key with fixed code system
1. Please follow the operating instructions for the
original hand-held transmitter.
2. The standard codes set at the factory must be
deleted before programming for the first time.
3. Point the original transmitter at the marked
position.
4. Press the button of the original hand-held trans-
mitter and the button to be allocated on the
keypad simultaneously (see illustration).
5. Keep both buttons depressed until light-
emitting diode B starts to flash (first slowly and
then quickly).
229
Parking
Advertisement
Table of Contents
