Table of Contents
Advertisement
Detection of obstacles during closing
The closing operation is interrupted if closing of
the rear lid is blocked by an obstacle.
A warning signal sounds and the rear lid opens
again by a few centimetres.
When the obstacle has been removed, the rear lid
can be closed by pressing the button in the rear lid
trim panel.
Adjusting the opening height of the rear lid
The opening height of the rear lid can be individu-
ally adjusted so that the rear lid does not collide
with the garage ceiling, for example.
On vehicles with level control, the vehicle height
changes depending on the setting of the level
control system. For this reason, always adjust the
opening height with the vehicle at the highest level
setting so that the rear lid cannot accidentally
collide with the garage ceiling, for example.
1. Stand behind the vehicle and open the rear lid.
2. Press the button
on the key to stop the
automatic opening operation at around 2/3 of
the opening height.
3. Now move the rear lid up by hand until the
desired opening height is reached. Make sure
that there is a sufficient minimum clearance
from any obstacle.
4. Press and hold the button in the rear lid trim
panel for approx. 3 seconds.
An acknowledgement signal sounds, and the
direction indicators light up once.
The opening height of the rear lid has now
been programmed.
The rear lid can now be closed by briefly
pressing the button.
This setting cannot be deleted. If a different
setting is required, repeat steps 1 to 4.
Malfunctions of the rear lid drive
The automatic function is not active if the battery
voltage is too low.
If a button is pressed, the rear lid lock is unlocked
and a warning signal sounds for 3 seconds. The
rear lid can now be opened by hand.
f Charge the vehicle battery.
Emergency operation of the rear lid
A warning signal sounds for approx. 3 seconds if
the automatic opening or closing operation is
interrupted by a fault.
f Open or close the rear lid by hand.
Opening and Locking
17
Advertisement
Table of Contents
