Phoenix Model Diamond Instruction Manual page 8

Instruction Manual
2. Locate the long piece of wire used for the
elevator pushrod. One end of the wire has
been pre-bend into a "Z " bend at factory. This
"Z" bend should be inserted into the control
horn for elevator.
3. Slide the wire pushrod into the fuselage.
4. Place the control horn onto the elevator, and
drill two 1.6mm holes through the elevator
using the control horn as a guide and screw the
control horn in place.
5. Install the metal connector to the servo arm of
the elevator servo.
25
6. Plug the elevator servo into the receiver and
center the servo. Install the servo arm onto the
servo.
7. Slide the elevator pushrod through the metal
connector.
8. Center the elevator and hold it in place using a
piece of masking tape.
9. With the elevator and the elevator servo center.
Secure the screw on the metal connector.
26
27
6
DIAMOND
28
29
30