Led Display On/Off; Dimmer Curve - ADJ UV 72IP User Instructions

UV 72IP

LED Display On/Off:

To set the LED display to turn off 60 seconds, press the MODE button
until "don" is displayed, press the UP button to display "doff". Now the
display will disappear after 60s. Press any button to turn the display on
again. Be advised though that the display will turn off automatically after
10 seconds.
To set the display press the MODE button until "dXX" is displayed. Use
the UP or DOWN buttons to select either:
"don" = LED display on at all times.
"doFF" = LED display shuts off after 60 seconds.
DMX Mode:
Operating through a DMX controller gives the user the freedom to
create their own programs tailored to their own individual needs. This
function also allows you to use your fixtures as spot lights. The UV
72IP has 3 DMX modes. See pages 9-10 for each modes' DMX traits.
1. This function will allow you to control each individual fixture's
traits with a standard DMX 512 controller.
2. To run your fixture in DMX mode press the MODE button until
"d.XXX" is displayed. "XXX" represents the current displayed ad-
dress. Use the UP or DOWN buttons to select your desired DMX
address, then press the SETUP button so that "Ch.XX" is displayed.
3. Use the UP or DOWN buttons to scroll through the DMX Channel
modes. The Channel modes are listed below:
• To run the 1 Channel Mode, press the UP or DOWN buttons until
"Ch01" is displayed. This is the 1 Channel DMX Mode.
• To run the 2 Channel Mode, press the UP or DOWN buttons until
"Ch02" is displayed. This is the 2 Channel DMX Mode.
• To run the 3 Channel Mode, press the UP or DOWN buttons until
"Ch03" is displayed. This is the 3 Channel DMX Mode.
4. Please see pages 9-10 for DMX values and traits.
5. After you have chosen your desired DMX Channel mode plug in
the fixture via the XLR connections to any standard DMX control-
ler.
ADJ Products, LLC - www.adj.com - UV 72IP User Manual Page 12
Operating Instructions UV 72IP
Slave Setting:
1. Plug the fixture in and press the MODE button until "SLAv" is
displayed. The unit now designate a "Slave" unit in a Master-Slave
set up.
UV Dimmer Mode:
1. Plug the fixture in and press the MODE button until "u: XXX" is
displayed. You are now in UV dimming mode. Press the UP and
DOWN buttons to adjust intensity.
2. After you have adjusted the output intensity you can then activate
strobing by pressing the SET UP button to enter the strobe mode.
3. "FS: XX" will be displayed, this is strobe mode. The strobe
can be adjusted between "00" (flash off) to "15" (fastest flash).

Dimmer Curve:

This is used to set the dimming curve used with DMX mode. See
page 17 for the different dimming curves.
1. Plug the fixture in and press the MODE button until the current
DMX address is displayed.
2. Press the SET UP button until "dr-X" is displayed. "X" represents
the displayed dimmer curve (0-4).
• 0 - Standard
• 1 - Stage
• 2 - TV
• 3 - Architectural
• 4 - Theatre
3. Press the UP or DOWN buttons to scroll through and select your
desired dimming curve.
Auto Fade Mode:
1. Plug the fixture in and press the MODE button until "Fd.XX" is
displayed. This is Auto Fade mode.
2. Use the UP and DOWN buttons to adjust the fade speed. "1"
being the slowest fade speed, and "16" being the fastest.
ADJ Products, LLC - www.adj.com - UV 72IP User Manual Page 13
Operating Instructions