Preparation; Define A Roll Id For The Test Series - Proceq PaperSchmidt Operating Instructions Manual

3.1

Preparation

If desired, define Roll IDs for the paper rolls under test using Paperlink and download these onto the
PaperSchmidt (See 7.8)
3.2

Define a Roll ID for the Test Series

The data list is the starting point for a new test series. Navigate within the data list by rolling the Pa-
perSchmidt either away from you or towards you.
There are 3 methods to define a Roll ID for a new test series.
Method 1 – Perform an impact
It is not necessary to define a specific Roll ID. Simply begin a measurement series by performing an
impact directly from the data list. Whatever upper/lower limits were previously set will be adopted
automatically for this series. In this case the actual 4-digit value of the internal impact counter is used
as a Roll ID and will appear in the review list once the series has been terminated.
Method 2 – Manual entry of the Roll ID
Method 3 – Select a pre-defined Roll ID
Note: A single pre-defined name can be used for a whole batch of rolls. In this case,
each time you move on to the next roll, select the same name again from the review
list and the device will increase an index which is used to identify that particular roll
in the list.
6
The upper section contains empty series with
pre-defined Roll IDs.
The lower section contains completed series
which can be reviewed.
Roll ID = Counter
Scroll to "NEW" and press the SELECT button.
Enter the Roll ID on the PaperSchmidt (see 3.5)
Accept or modify the upper/lower limits (see 3.6)
and begin measuring the roll hardness profile.
Scroll to the desired pre-defined Roll ID in the up-
per section of the data list and press the SELECT
button.
Accept or modify the upper/lower limits (see 3.6)
and begin measuring the roll hardness profile.
© 2009 by Proceq SA