Table of Contents
Advertisement
NOTES
• When slow & fast motion recording is activated, the time code signal cannot be output from the SDI OUT
terminal (m only) or HDMI OUT terminal.
• The HDMI OUT terminal is for output only. Do not connect the camcorder to another device's output terminal
using the HDMI OUT terminal as this will cause a malfunction.
• Correct operation cannot be guaranteed when connecting the camcorder to DVI monitors.
• Video may not be output correctly depending on the monitor. m In such case, try using the SDI OUT
terminal.
• You can set both [3 Recording Setup] > [Rec Command] and [HDMI Time Code] to [i On] to use the
camcorder's REC button to control also the recording operation of an external recorder connected to the
HDMI OUT terminal. The camcorder's time code signal will be output as well.
• The time code signal will not be output from the HDMI OUT terminal in the following cases.
- In
mode.
- During SD (720x576) output.
- When slow & fast motion recording is activated.
• When the resolution is set to [3840x2160 (150 Mbps)] and the frame rate is set to 50.00P (A 46), to view the
camcorder's output signal on a TV or external monitor connected using an optional High Speed HDMI cable,
the TV or external monitor must be compatible with 4K/50p video.
Connecting to an External Monitor or Recorder
109
Advertisement
Table of Contents
