Table of Contents
Advertisement
The Pivot Arms (5) can be adjusted to allow for a greater or lesser degree of inversion. To
adjust the Pivot Arms (5) simply pull out on them until the post is out of the hole, slide them up
or down to the desired hole, push in until the post goes through the desired hole, The bottom
hole provides the least amount of inversion, while the top hole provides the greatest amount,
It is recommended that beginners use the bottom hole until they are familiar with the inversion
table.
NOTE: Both Pivot Arms (5) must be adjusted to the same hole. Trying to adjust the Pivot
Arms (5) on two different positions could cause damage to the inversion table, or injury to the
user.
Pivot arm is NOT aligned correctly.
The pivot arm is not inserted all the
way into the curved slot.
WARNING: Make sure both pivot arms are in the same hole to prevent
serious injury from occurring.
OPERATION AND ADJUSTMENTS
18
Make sure the pivot arm is inserted
all the way into the slot. Pivot arm is
aligned correctly when the groove
sits directly on the curved slot and
the pivot arm is able to rotate freely.
Advertisement
Table of Contents
