Table of Contents
Advertisement
Step 5
Slide the Rod (9) through the large round hold on the side of Adjustable Boom (3), and secure
the Rod (9) on the Adjustable Boom (3) with a Hex Head Bolt (11), Lock Nut (16), and two
Washers (27).
Slide one Steel Heel Holder Bracket (7) and one Rubber Heel Holder (31) onto one end of the
Rod (9) until the lock tooth is wedged into the slot in the Rod (9) as shown in Fig. AA-1. Use
the same procedure to attach the other Steel Heel Holder Bracket (7) and Rubber Heel Holder
(31) onto the other end of the Rod. (9).
NOTE: Make sure the lock teeth are wedged into the slots in the Rod (9) to lock the Steel Heel
Holder Brackets (7) and Rubber Heel Holders (31) in place before use.
Hardware:
(11) Hex Head Bolt
M6*47 1PC
ASSEMBLY
(27) Washer
Ø16*Ø6.5*1.0
2PCS
12
Tool:
Wrench 2PCS
(16) Lock Nut M6
1PC
Advertisement
Table of Contents
