Operation And Adjustments - Ironman Fitness iControl 5620 Owner's Manual

Disk brake system inversion table
Table of Contents

Advertisement

Using the Handlebars
For added convenience and safety, a set of Handlebars has been added to the inversion
table. These Handlebars are located at the top of the Rear Frames. The Handlebars are
there to help you return to the upright position from any degree of inversion. If you wish to
return to the upright position, and the bed is moving too slowly, or not moving at all,
simply grab the Handlebars and pull on them until you return to the upright position.
NOTE: The inversion table should always return to the upright position when you move
your hands below your waist. If it does not, the inversion table is not adjusted correctly to
your height.
Always hold on to the handlebars and go back slowly. Failure to comply could result in
serious physical injury.
1.
It is recommended that someone be with you while you are using this inversion
table for the first few times.
2.
Make sure that the Rubber Heel Holders and Front Heel Holders are holding your
Legs securely.
3.
Make sure that the Adjustable Boom (8) is properly set to your height.
4.
Make sure that the Adjustable Boom (8) is held securely by both the Boom Spring
Knob (18) and the Knob (30).
5.
Make sure that there is enough room for the bed to rotate completely.
BALANCING THE INVERSION TABLE
The inversion table is a very sensitively balanced fulcrum. It responds to very slight
changes in weight distribution. It is very important to make sure that the height is
adjusted properly. To do this, mount the inversion table, lock your ankles into the heel
holders, and lie back with your hands at your sides. Slowly place your hands across your
chest. While in this position, your head should still be above your feet. If your feet are
above your head, return to the upright position and then dismount and adjust the height
again.
Note: If the bed does NOT rotate when trying to invert, Decrease the height of the
adjustment boom.
If the bed rotates TOO FAST when inverting, Increase the height of the adjustment
boom.
OPERATION AND ADJUSTMENT
GENERAL PRECAUTIONS
21

Advertisement

Table of Contents
loading

Table of Contents