Configuring The Ap Using Cli Commands; Log Into The Ap Using Hyperterminal - Avaya Wireless AP-3 User Manual

Configuring the AP using CLI commands

Configuring the AP using CLI commands

Log into the AP using HyperTerminal

1. Open your terminal emulation program (like HyperTerminal) and
set the following connection properties:
— Com Port: <COM1, COM2, etc., depending on your computer>
— Baud rate: 9600
— Data Bits: 8
— Stop bits: 1
— Flow Control: None
— Parity: None
2. Under File -> Properties -> Settings -> ASCII Setup, enable the
Send line ends with line feeds option.
Result: HyperTerminal sends a line return at the end of each line
of code.
3. Enter the CLI password (default is public).
NOTE:
Avaya recommends changing your default passwords immediately.
To perform this operation using CLI commands, refer to
Passwords.
A-36
Change
Avaya Wireless AP-3 User's Guide