Avaya Wireless AP-3 User Manual page 277

Recovery Procedures
10. Enter the Image File Name (including the file extension). Enter the
full directory path and file name. If the file is located in the default
TFTP directory, you need enter only the file name.
11. Click OK.
— Result: The Access Point will reboot and the download will
begin automatically. You should see downloading activity
begin after a few seconds within the TFTP server's status
screen.
12. Click OK when prompted that the device has been updated
successfully to return to the Scan List screen.
13. Click Cancel to close the ScanTool.
14. When the download process is complete, configure the AP as
described in
Download a New Image Using the Bootloader CLI
To download the AP Image, you will need an Ethernet connection to the
computer on which the TFTP server resides. This can be any computer
on the LAN or connected to the AP with a cross-over Ethernet cable.
You must also connect the AP to a computer with a standard serial cable
and use a terminal client, such as HyperTerminal. From the terminal,
enter CLI Commands to set the IP address and download an AP Image.
7-22
Getting Started and Advanced Configuration.
Avaya Wireless AP-3 User's Guide