AMQ ACTIV-Pro3 Installation Manual page 7

Phase 5 Connecting Worksurface & Power
1
Attach the base assembly to the worksurface
2
Ensure that the base is properly positioned to the worksurface
3
Attach the base to the worksurface using wood screws
4 Attach the handset to desired location using handset screws (count x 2)
5
1 Ensure that the base is properly positioned on Plug in electrial according to below drawing and attach cable management clips, if desired
the worksurface. Attach base to the worksurface
Note : The worksurface should be centeraligned with the cantilever depth
using wood screws.
Note: The worksurface should be center
aligned with the cantiliver depth and should
have equal amount of overhang on each end.
2 Attach the handset to desired location using
handset screws (count x2)
Plug in electrical according to the diagram at
3
right. Attach cable management clips if using.
P7 Please contact
and should have equal amount of overhang on each end
1
3
cc@amqsolutions.com if you are missing any parts, have difficulty with assembly, or have any product related questions.
Facing
Direction
Connect each plugs according to the drawing.
Orientate yourself to the table assembly by
facing as user to identify left and right motor.
ACTIV-Pro3 Installation Guide
3
2
4