Connector board
NOTE:
The connector board spare part kit does not include the connector board cable. The connector
board cable is available using spare part number L01846-001.
Description
Connector board (includes the card reader slot, USB port, and RJ45 jack)
Before removing the connector board, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the computer.
4.
Remove the bottom cover (see
5.
Remove the battery (see
Remove the connector board:
1.
Release the ZIF connector (1) to which connector board cable is connected, and then disconnect
the connector board cable from the connector board.
2.
Remove the two Phillips M2.0×3.0 screws (2) that secure the connector board to the keyboard/top cover.
3.
Remove the connector board (3).
Reverse this procedure to install the connector board.
Bottom cover on page
Battery on page
33).
31).
Component replacement procedures
Spare part number
L01845-001
47