Setup Output Communications; Configuring Data Push Parameters - Wavetronix smartsensor advance User Manual

9

Setup Output Communications

In this chapter
˽ Configuring Data Push Parameters
9
The SmartSensor Advance is normally configured to operate in data push mode on port 2,
which means that the sensor initiates each output data transfer, instead of responding to
data requests from another device. The features located in the Setup Output Communica-
tion screen allow you to configure the data push parameters (see Figure 9.1).
Figure 9.1 – Setup Output Communications

Configuring Data Push Parameters

This section describes the four settings contained in the Output Communication Setup
screen.