Download Print this page

Installation; Water Connection - Westinghouse WSU67381 User Manual

Freestanding and built under type
Hide thumbs

Advertisement

INSTALLATION

General
When determining where to put your machine,
choose a place where you can easily load and unload
your dishes�
Do not put your machine in any location where
there is a probability for the room temperature to
fall below 0°C�
Before positioning, take the machine out of its
packaging by following the warnings located on
the package�
Position the machine close to a water tap or
drain� You need to site your machine, taking into
consideration that its connections will not be altered
once they are made�
Do not grip the machine by the door in order to move it�
Leave a clearance on all sides of the machine so that
you can comfortably move it back and forth during
cleaning�
Make sure that the water inlet and outlet hoses
aren't squeezed while positioning the machine�
Also, make sure that the machine does not stand
on the electrical cable�
Adjust the machine's adjustable feet so that it can
stand level and balanced� Proper positioning of the
machine ensures problem-free opening and closing of
the door�
If the door of your machine does not close properly,
check if the machine is stable on the floor it stands;
if not, adjust the feet and ensure its stable position�

Water connection

Connect the inlet hose to a water tap with an external
BSP thread spout of 3/4"� The indoor plumbing is to
comply with AS/NZS 3500�1�
For best washing performance it is recommended to
connect the appliance to a cold water supply�
Energy savings can be made by connecting the appliance
to a solar water system and using economy options,
however the water temperature must not exceed 60°C
WARNING
CAUTION
Only turn the locking nut to secure the hose. Do not
turn the hose.
Inlet water supply
Water pressure: 800kPa max – 50 kPa min�
Water flow rate 10 L/minute�
If water pressure is in excess of 800 k Pa, a pressure
reducing valve should be used� Check for leaks�
If water temperature is in excess of 60°C, a tempering
valve should be used� Check for leaks�
WARNING
CAUTION
Always use new hoses when you connect the appliance to
the water mains� Old hoses must not be used� The water
inlet hose must be examined at an interval of twelve
months for deterioration and replaced if necessary�
In order to pass the safety valve through the kitchen
cabinets, an opening of at least 45mm x 90mm is needed�
Water drain hose
The water drain hose can be connected either directly to
the water drain hole or to the sink outlet spigot� Using a
special bent pipe (if available), the water can be drained
directly into the sink via hooking the bent pipe over the
edge of the sink� This connection should be at a minimum
of 50cm and at a maximum of 110cm from the floor�
WARNING
CAUTION
When a drain hose longer than 4m is used, the dishes
wont be cleaned properly and might remain dirty.
30cm
min�
min� 4cm
Floor level
INSTALLATION
11

Hide quick links:

Advertisement

loading

This manual is also suitable for:

Wsf67381Wsf67251Wsf6725i