INSTALLATION
In some cases you may need to remove the top concrete
counterwieght and trim the felt with a knife� To remove
the counterweight, follow the steps below�
WARNING
CAUTION
If the counterweight has been removed, the dishwasher
must be stabilised by wedging a piece of timber between
the dishwasher and the underside of the countertop.
To remove the felt and the dishwasher support blocks:
Lift and cut felt�
Remove 2 blocks of foam as shown�
Finishing the installation
1�
Fit the steam protection tape to the underside of the
countertop�
2� Adjust the dishwasher feet according to the slope of the
floor then carefully slide the dishwasher into the cavity�
570mm
820mm
min. 600mm*
WARNING
CAUTION
When installing the dishwasher into the cavity, take care
not to crush or kink the hoses or electrical cable.
steam protection foil
tape #ES6060 from
spare parts
*recommended opening
INSTALLATION
13