Maintenance And Cleaning - Westinghouse WSU67381 User Manual

MAINTENANCE AND CLEANING

TIPS & INFORMATION
IMPORTANT
Cleaning the machine in regular intervals prolongs the
machine's service life�
Oil and lime may accumulate in the machine's
washing section. In case of such accumulation;
• Fill the detergent compartment without loading
any dishes into the machine, select a program that
runs at high temperature, and start the machine� If
this is ineffective, use a specialty dishwasher cleaner
available from most supermarkets�
Cleaning the seals in the machine door
• To clean any accumulated residues in the door seals,
wipe the seals regularly by using a dampened cloth�
Cleaning the machine
• Clean the filters and spray arms at least once a week�
• Unplug your machine and turn off its tap before
starting the cleaning�
• Do not use hard materials when cleaning your
machine� Wipe with a fine cleaning material and a
dampened cloth�
Filters
• Check if any food wastes have remained on the
coarse and fine filters�
• If any food wastes are left, remove the filters and
clean them thoroughly under the water tap�
a Micro Filter
b
Coarse Filter
c Metal/Plastic Filter
To remove and clean the filter combination, turn it counter
clockwise and take it out by lifting upwards�
Pull and remove the metal/plastic filter�
Then pull the coarse filter out of the micro filter�
Rinse it with lots of water under the tap� Refit the
metal/plastic filter� Insert the coarse filter into the micro
filter in away that the marks will correspond to one
another� Attach micro filter into the metal/plastic filter
and turn to the direction of arrow and it is locked when
the arrow on micro filter can be seen from across�
• Never use your dishwasher without any filter�
• Incorrect fitting of the filter will reduce the washing
effectiveness�
• Clean filters are very important in terms of the proper
running of the machine�
24
MAINTENANCE AND CLEANING
.
b
a
Spray arms
Check whether or not the holes for the upper and lower
spray arms are clogged� If there is any clogging, remove
the spray arms and clean them under water�
You can remove the lower spray arm by pulling it
upwards, while the upper spray arm nut can be removed
by turning the nut to the left�
Be sure that the nut is perfectly tightened when refitting
the upper spray arm�
1
3
2
Hose filter
Water is stopped by the inlet hose filter to avoid any
damage to your machine because of any contamination
4
(sand, clay, rust etc�) that might be occasionally carried in
through the mains water supply or the indoor plumbing,
and to forestall such issues as yellowing and formation
of deposits after washing� Check the filter and the hose
from time to time and clean them if necessary� To clean
the filter, first turn off your tap and then remove the hose�
After removing the filter from the hose, clean it under the
tap� Insert the cleaned filter back into its place inside the
hose� Refit the hose�
c
1
2
3
4