Installation - Westinghouse WSF67251 User Manual

Hide thumbs Also See for WSF67251:
Table of Contents

Advertisement

INSTALLATION

remove
entire internal
membrane
Correct
0.5–1.1m
Incorrect
Installing a freestanding dishwasher
If the under counter height is greater than 850mm,
the dishwasher can be installed without removing the
worktop.
If the under counter space is less than 850mm but greater
than 820mm the worktop will need to be removed.
To remove the worktop, remove the screws located at
the rear of the machine, then, from the front, push the
worktop towards the rear and lift.
To ensure stabilityof the dishwasher in an undercounter
installation, any gap between the dishwasher and the
underside of the countertop should be bridged with a
packing piece. This may be achieved by wedging a piece
of timber between the dishwasher and the underside of
the countertop.
timber
wedging
piece
filler piece
benchtop
to suit
installation
3mm gap
INSTALLATION
In some cases you may need to remove the top concrete
counterwieght and trim the felt with a knife. To remove
the counterweight, follow the steps below.
WARNING
CAUTION
If the counterweight has been removed, the dishwasher
must be stabilised by wedging a piece of timber between
the dishwasher and the underside of the countertop.
To remove the felt and the dishwasher support blocks:
Lift and cut felt.
Remove 2 blocks of foam as shown.
Finishing the installation
1.
Fit the steam protection tape to the underside of the
countertop.
steam protection foil
tape #ES6060 from
spare parts
2. Adjust the dishwasher feet according to the slope of the
floor then carefully slide the dishwasher into the cavity.
570mm
820mm
min. 600mm*
*recommended opening
WARNING
CAUTION
When installing the dishwasher into the cavity, take care
not to crush or kink the hoses or electrical cable.
Page 12, 13
INSTALLATION

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents