Keithley 6430 Quick Results Manual page 42

HILIM - Use to enter the high limit value. You will then be prompted to enter the bit
pattern for binning operations. Since binning operations are being done at this time, press
ENTER or EXIT.
Limit testing operation
1. Connect the DUT to the SourceMeter.
2. Configure the source-measure functions of the SourceMeter.
3. Select and configure a limit test as previously explained.
4. Turn the output on.
5. Press the LIMIT key to enable the test. The pass/fail status of the test will be displayed.
The test can be disabled by again pressing the LIMIT key.
Remote command programming
SCPI commands
SCPI commands for basic non-binning limit testing are listed in Table 17.
NOTE Table 17 does not provide a complete listing of limit commands. See the
Instruction Manual
Table 18
SCPI commands: basic non-binning limit testing
*
Command
For all limit tests:
:CALCulate2:DATA?
Limit 1 test:
:CALCulate2:LIMit:STATe <b>
:CALCulate2:LIMit:COMPliance:FAIL <.name> Set Limit 1 fail condition: <name> = IN (fail if in
:CALCulate2:LIMit:FAIL?
Limit 2, 3, 5-12 tests:
:CALCulate2:LIMitX:STATe <b>
:CALCulate2:FEED <name>
:CALCulate2:LIMitX:LOWer <n>
:CALCulate2:LIMitX:UPPer <n>
:CALCulate2:LIMitX:FAIL?
*LIMitX = LIMit2, LIMit3, LIMit5 through LIMit12.
for complete documentation.
*
Description
Acquire limit test reading(s).
Enable/disable Limit 1 test: <b> = ON or OFF.
compliance) or OUT (fail if not in compliance).
Query Limit 1 test result (0 = pass, 1 = fail).
Enable/disable Limit X test: <b> = ON or OFF.
Select input path: <name> = CALCulate[1],
VOLTage, CURRent or RESistance.
Set lower limit for Limit X: <n> = limit.
Set upper limit for Limit X: <n> = limit.
Query Limit X test result (0 = pass, 1 = fail).
Quick Results Guide
Model 6430
35