Keithley 6430 Quick Results Manual page 38

Remote command programming
SCPI commands
SCPI commands for linear, logarithmic and custom sweeps are listed in Table 16.
NOTE Table 16 does not provide a complete listing of sweep commands. Documentation
for all sweep commands can be found in Section 9 of the Model 6430 SourceMeter
Instruction Manual.
Table 16
SCPI commands: sweeping
*
Command
:SOURce:xxx:MODE <name>
:SOURce:DELay <n>
:SOURce:DELay:AUTO <b>
:TRIGger:COUNt <n>
Linear and logarithmic sweeps:
:SOURce:SWEep:SPACing <name> Select sweep scale: <name> = LINear or
:SOURce:SWEep:RANGing
<name>
:SOURce:xxx:STARt <n>
:SOURce:xxx:STOP <n>
:SOURce:xxx:STEP <n>
:SOURce:SWEep:POINts <n>
Custom (list) sweep:
:SOURce:LIST:xxx <list>
:SOURce:LIST:xxx:APPend <list>
:SOURce:LIST:xxx:POINts?
Source memory sweep:
:SOURce:FUNCtion MEM
:SOURce:MEMory:SAVE <n>
:SOURce:MEMory:RECall <n>
:SOURce:MEMory:STARt <n>
:SOURce:MEMory:POINts <n>
*:xxx = :VOLTage or :CURRent.
Quick Results Guide
Description
Select source mode: <name> = FIXed, LIST or
SWEep.
Set source delay: <n> = 0 to 9999.9980 (sec).
Enable/disable auto delay: <b> = ON or OFF.
Set trigger count: <n> = Number of points in
sweep.
LOGarithmic.
Select source ranging: <name> = BEST, AUTO, or
FIXed.
Specify sweep start level: <n> = V or I source
value.
Specify sweep stop level: <n> = V or I source
value.
Specify linear sweep step level: <n> = V or I source
value.
Set number of sweep points: <n> = 2 to 2500.
Define source list: <list> = value1, value2, ...
valueN.
Add source list value(s): <list> = value1, value2, ...
valueN.
Query length of source list.
Select source memory sweep mode.
Save setup in memory location: <n> = 1 to 100.
Return to specified setup: <n> = 1 to 100.
Set source memory start location: <n> = 1 to 100.
Specify number of sweep points: <n> = 1 to 100.
31