22
Quick Results Guide
NOTE
Remote command programming
The SCPI commands for speed, digits, filter, and rel are listed in Table 13. The commands for
ranging are listed in Tables 7 and 8.
Table 13
SCPI commands: speed, digits, filter, and rel
Command
1
Speed commands
:
[:SENSe]:CURRent:NPLCycles <n>
[:SENSe]:VOLTage:NPLCycles <n>
[:SENSe]:RESistance:NPLCycles <n>
Digits command:
:DISPlay:DIGits <n>
Auto filter command:
[:SENSe]:AVERage:AUTO <b>
Repeat filter commands:
[:SENSe]:AVERage:REPeat:COUNt <n>
[:SENSe]:AVERage:REPeat[:STATe] <b>
Median filter commands:
[:SENSe]:MEDian:RANK <NRf>
[:SENSe]:MEDian[:STATe] <b>
Moving filter commands:
[:SENSe]:AVERage:COUNt <n>
[:SENSe]:AVERage[:STATe] <b>
[:SENSe]:AVERage:ADVanced:NTOLerance <NRf>
[:SENSe]:AVERage:ADVanced[:STATe] <b>
2
Rel command
:
:CALCulate2:NULL:STATe <b>
1. The speed setting is global for all functions. Therefore, you can use any of the three commands to set speed.
2. The commands to acquire a rel value are not listed in this table (see Section 7 Relative in the Model 6430 SourceMeter Instruction
Manual).
Rel can also be used to establish a baseline reading. The baseline reading will be
subtracted from present and future readings. See "Relative" in Section 7 of the
Model 6430 SourceMeter Instruction Manual for details.
Description
Set measurement speed: <n> = 0.01 to 10.
Set measurement speed: <n> = 0.01 to 10.
Set measurement speed: <n> = 0.01 to 10.
Set display resolution: <n> = 4, 5, 6, or 7.
Enable/disable auto filter: <b> = ON or OFF.
Set repeat filter count: <n> = 1 to 100.
Enable/disable repeat filter: <b> = ON or OFF.
Set median filter rank: <NRf> = 0 to 5.
Enable/disable median filter: <b> = ON or OFF.
Set average filter count: <n> = 1 to 100.
Enable/disable filter: <b> = ON or OFF.
Set advanced filter noise window: <NRf> = 0 to 105.
Enable/disable advance filter: <b> = ON or OFF.
Enable/disable rel: <b> = ON or OFF.