progeo JOKER ENERGY User Manual page 33

After the adjustment, check the front wheel, when
rotating, does not touch the footplate.
Angle adjustment: this adjustment allows to change the
inclination of the footplate in accordance with a more comfortable
and correct position of the feet. Such adjustment can be perform
only if the wheelchair is equipped with the carbon fibre (fig. 48a) or
aluminum (fig. 49) angle adjustable footplate.
With carbon fibre footplate
Loosen the bolt "A" (5mm Allen key) and the headless bolt
"B" (3mm Allen key) (fig.48a) on both supports.
Turn the plate clockwise or anticlockwise to adjust its
inclination (see figures 48b) and to find the ideal position to
support the feet
Finally tighten all bolts firmly.
With aluminum footplate
The support tube for the footrest has several pre-drilled holes and the
frame has a further hole allowing the height of the footrest to be
adjusted (figure 49).
8 3-4
S
B
Remove the bolts and nuts "A" (3mm Allen key and 8mm
spanner) that fix the aluminium plate that is now to be
removed.
Loosen the bolts and nuts "B" on the central support "S"
(4mm Allen key and 10mm spanner).
These first two steps are necessary to make the distance
between the two footplates tubes wider or narrower so as to
keep the same tapering inclination of the fames. In fact the
width of the footplate changes with relation to its length : the
longer footplate distance, the narrower its width.
Remove the bolts, washers and nuts "C" and "C
key and 8mm spanner.
Slide the footplate tubes up or down to the desired height.
Insert the bolts "C" into the nearest holes and tighten them
JOKER ENERGY
C C
1
A
Fig. 49
S
" (4mm Allen
1
33