Important Notice - Emerson Rosemount 708 Quick Installation Manual

Wireless acoustic transmitter

Hide thumbs Also See for Rosemount 708:

Reference manual (48 pages)

Quick start manual (36 pages)

Quick start manual (20 pages)

Table Of Contents

Table of Contents

Rosemount 708

Standard Terms and Conditions of Sale can be found at www.rosemount.com/terms_of_sale

The Emerson logo is a trade mark and service mark of Emerson Electric Co.

Rosemount and the Rosemount logotype are registered trademarks of Rosemount Inc.

Emerson Process Management

Rosemount Division

8200 Market Boulevard

Chanhassen, MN USA 55317

T (US) (800) 999-9307

T (Intnl) (952) 906-8888

F (952) 906-8889

This installation guide provides basic guidelines for the Rosemount

provide instructions for detailed configuration, diagnostics, maintenance, service,

troubleshooting, or installations. Refer to the Rosemount 708 Reference Manual

(Document Number 00809-0100-4708) for more instruction. This guide and the manual

are available electronically on www.rosemount.com.

Explosions could result in death or serious injury:

Installation of this transmitter in an explosive environment must be in accordance with the appropriate

local, national, and international standards, codes, and practices. Please review the Product

Certifications section for any restrictions associated with a safe installation.

• Before connecting a Field Communicator in an explosive atmosphere, ensure the instruments are

installed in accordance with intrinsically safe field wiring practices.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following conditions.

This device may not cause harmful interference. This device must accept any interference received,

including interference that may cause undesired operation.

This device must be installed to ensure a minimum antenna separation distance of 8 in. (20 cm) from

all persons.

The Power Module may be replaced in a hazardous area. The Power Module has surface resistivity

greater than one gigaohm and must be properly installed in the wireless device enclosure. Care must

be taken during transportation to and from the point of installation to prevent a potential electrostatic

charging hazard.

Polymer enclosure has surface resistivity greater than one gigaohm. Care must be taken during

transportation to and from the point of installation to prevent a potential electrostatic charging hazard.

Shipping considerations for wireless products:

The unit was shipped to you without the Power Module installed. Please remove the Power Module

prior to shipping the unit.

Each Power Module contains one "D" size primary lithium battery. Primary lithium batteries are

regulated in transportation by the U.S. Department of Transportation, and are also covered by IATA

(International Air Transport Association), ICAO (International Civil Aviation Organization), and ARD

(European Ground Transportation of Dangerous Goods). It is the responsibility of the shipper to

ensure compliance with these or any other local requirements. Please consult current regulations and

requirements before shipping.

Rosemount Temperature GmbH

Frankenstrasse 21

63791 Karlstein

Germany

T 49 (6188) 992 0

F 49 (6188) 992 112