UPRtek PG100N User Manual page 5

2.1 Preparing Before Use
Battery installation ：
Step1. Hold PG100N, then press the battery cover.
Step2. Press the battery cover down to remove it.
Step3. Install the battery after removing battery cover.
1
※ Press battery cover downward to unlock it
from cover latch before pushing it outward of the
body
Charge the battery full for 6 hours before using it for the first time.
1.
To prevent power outage during using this product, please check
2.
whether the red light has turned off (fully charged) according to
instructions given in next page item1. Once this product is
enabled keep an eye on indicator of balance of battery charge at
upper right corner of screen.
In case a battery goes exhausted soon after fully charged then its
3.
life cycle has ended. Please call your dealer for replacement with
new one.
Time span your battery can last varies with its life cycle. Newly
4.
shipped battery after full charge may last around 5 hours.
05
3
2
2.1 Preparing Before Use
Charge your battery ：
Connect charger to charging port of this product to start
charging its battery.
1. Product in off mode: The power key lights red during battery
charging and turns off after it is fully charged.
2. Product in on mode: A flash symbol displays at upper right
corner of screen of this product during charging and disappears
after it is fully charged.
06