Appearance Introduction; Annual Product Calibration; Product Notes And Precautions - UPRtek PG100N User Manual

1.3 Appearance Introduction

sensor cover
3.5" touch panel
DC power connector
mini USB port
If the system crashes, please press the power key for 3 seconds to
1.
turn off the system.
If the problem still can't be fixed, please use a pin to press the
2.
reset key to turn off the system.
03
optical sensor
SD card slot
reset key
power key
measure key
battery cover

1.4 Annual Product Calibration

As the product is a high-precision instrument, please use it cautiously.
To ensure the accuracy of measurements, annual calibration is
recommended. Please consult the agent or the customer service
department for the calibration service.

1.5 Product Notes and Precautions

1.
PG100N Spectrometer is a high-precision instrument. Please unpack with care.
Any vibration or collision may cause instrument damage. If the product doesn't
work normally or needs repair, please don't attempt any repairs. All repairs must
be performed by the authorized customer service agent.
Most LCD screens have a very small and inconsequential defective pixel rate
2. (usually less than 0.1%). This results in occasional pinpoints of white or other
colors but will not affect the accuracy of measurements.
Precautions / Warnings
Please read the following precautions to avoid fire, excessive heat, chemical leakage
and explosion :
■
Do not disassemble or modify the battery.
■
Do not expose the battery to heat (fire) or water/moisture.
■
When disposing used/old batteries, wrap with insulation tape to shield the
battery from electrical contact with metallic objects, which might ignite a fire or
explosion.
■
If the unit is plugged into the power adapter and the battery seems to be
overheating, or if there is smoke or peculiar odors emanating from the unit,
unplug immediately to avoid the possibility of fire.
■
However, do not touch the cables if there is heat emanating from near the cables
as melted or deformed cables could expose wiring and result in burns or electric
shock.
■
Do not use cloth or anything to wrap or cover the equipment while charging –
this could cause the unit to overheat, melting the casing or causing fire.
■
If the unit is accidently immersed in water, or if moisture has seeped inside, or
metal objects have dropped into the casing, immediately remove the battery to
avoid fire or electric shock.
■
Do not operate or store the battery in high-temperature environments-it will
cause battery leakage and/or shorten the life of the battery .
■
Do not use paint thinner, benzene or other organic solvents to clean the
equipment – this may damage the exterior finish or touch screen, and may even
ignite fire.
04