Operating Instructions - ADJ MEGA HEX PAR User Instructions

Mega HEX Par
LED Display On/Off:
To set the LED display to turn off after 10 seconds, press the MODE button until "don" is displayed,
press the UP button to display "doff". Now the display will disappear after 10s. Press any button to
turn the display on again. Be advised though that the display will turn off automatically after 10 sec-
onds.
To set the display press the MODE button until "dXX" is displayed. Use the UP or DOWN buttons to
select either:
"don" = LED display on at all times.
"doFF" = LED display shuts off after 10 seconds.
LED Display Inversion:
Follow these instructions to flip the display 180° so that the display can be read upside down.
1. Plug the fixture in and press the MODE button until "dXX" is displayed. "XX" represents either
"on" or "oFF".
2. Press the SET UP button until "Stnd" is displayed.
3. Press the UP or DOWN buttons to reverse the display 180°.
Operating Modes:
The Mega HEX Par has five operating modes:
• DMX control mode - This function will allow you to control each
individual fixtures traits with a standard DMX 512 controller.
• RGBWA + UV Mode - Choose one of the six colors to remain static or adjust the intensity of each
color to make your own color.
• Sound-Active mode - The unit will react to sound, chasing through the built in programs. There are
16 sound active modes.
• Auto Mode - There are 33 Auto Modes to choose from. 16 color fade modes, 16 color change
modes, and 1 combination mode.
• Static Color Mode - There are 63 colors to choose from.
Static Color Mode:
1. Plug the fixture in and press the MODE button until "CLXX" is displayed.
2. There are 63 colors to choose from. Select your desired color by pressing the UP and DOWN
buttons. After you have selected your desired color you can activate strobing by pressing the
SET UP button to enter the Flash (strobe) mode.
3. "FS.XX" will be displayed, this is Flash mode. The Flash can be adjusted between "FS.00" (flash
off) to "FS.15" (fastest flash).
Sound Active Mode:
In this mode the Mega HEX Par will react to sound, and chase through the different colors.
1. Plug the fixture in and press the MODE button until "SoXX" is displayed. "XX" represents the
sound active mode (1-16) currently displayed. Use the UP and DOWN buttons to scroll through
the sound active modes.
2. After you have found your desired sound active mode, press the SET UP button to adjust the
sound sensitivity. "SJ-X" will be displayed. Use the UP and DOWN buttons to adjust the sensitivity.
"SJ-1" is the lowest sensitivity, "SJ-8" is the highest.
ADJ Products, LLC - www.adj.com - Mega HEX Par User Manual Page 9

Operating Instructions