ADJ MEGA HEX PAR User Instructions page 12

Mega HEX Par
Auto Run Mode:
There are 3 types of Auto Run Modes to choose from; Color Fade, Color Change, and both modes
running together. The running speed is adjustable in all 3 modes.
1. Plug the fixture in and press the MODE button until either "AFXX", "AJXX", or "A-JF" is displayed.
Press the SET UP Button to change between the 3 Auto Run modes
• AFXX = Color Fade mode, there are 16 Color Fade modes to choose from. Use the UP or DOWN
buttons to scroll through the different Auto Fade modes.
• AJXX = Color Change mode, there are 16 Color Change modes to choose from. Use the UP or
DOWN buttons to scroll through the different Auto Change modes.
• A-JF = Both Color Fade and Color Change modes running.
2. After you have chosen your desired running mode press the SET UP button until "SP.XX" is
displayed. When this is displayed you can adjust the running speed of your desired program. Use
the UP or DOWN button to adust the speed between "SP.01" (slowest) and "SP.16" (fastest).
Once you have set your desired running speed, press the SET UP button to return to your
desired Auto Run Mode.
ADJ Remote Activation:
This function is used to activate and deactivate the IR sensor. When this function is activated you
can control the fixture using either the ADJ UC IR or Airstream App. Please see page 14 for the con-
trols and functions.
1. Plug the fixture in and press the MODE button until "dXX" is displayed. "XX" represents either
"on" or "oFF".
2. Press the SET UP button until "IrXX" is displayed. "XX" represents either "on" or "oF".
3. Press the UP or DOWN buttons to either activate the remote function (On) or deactivate it (Off).
DMX State:
This mode can be used as a precaution mode, that in case the DMX signal is lost, the operating mode
chosen in the setup is the running mode the fixture will go into when the DMX signal is lost. You can
also set this as the operating mode you would like the unit to return to when power is applied.
1. Plug the fixture in and press the MODE button until "d.XXX" is displayed. "XXX" represents the
current displayed DMX address.
2. Press the SET UP button so that "nodn" is displayed. Use the UP and DOWN buttons to scroll
through the DMX states.
• "bLAC" (Blackout) - If the DMX signal is lost or interrupted, the unit will automatically go into
stand by mode.
• "LASt" (Last State) - If the DMX signal is lost or interrupted, the fixture will stay in the last DMX
set up. If power is applied and this mode is set, the unit will automatically go into the last DMX set
up.
• "ProG" (Auto Run) - If the DMX signal is lost or interrupted, the unit will automatically go into Auto
Run mode.
3. Use the UP and DOWN buttons to find your desired DMX state and press SET UP to confirm and
exit.
ADJ Products, LLC - www.adj.com - Mega HEX Par User Manual Page 11
Operating Instructions