ADJ MEGA HEX PAR User Instructions page 11

Mega HEX Par
DMX Mode:
Operating through a DMX controller gives the user the freedom to create their own programs tailored
to their own individual needs. The Mega HEX Par has 5 DMX modes: 6 Channel mode, 7 Channel
mode, 8 Channel mode, 11 Channel mode, and a 12 Channel mode.
1. To run your fixture in DMX mode press the MODE button until "d.XXX" is displayed. "XXX"
represents the current displayed address. Use the UP or DOWN buttons to select your desired
DMX address, then press the SETUP button to select your DMX Channel mode.
2. Use the UP or DOWN buttons to scroll through the DMX Channel modes. The Channel modes
are listed below:
• To run the 6 Channel Mode, press the MODE button until "Ch06" is displayed. This is the
6 Channel DMX Mode.
• To run the 7 Channel Mode, press the MODE button until "Ch07" is displayed. This is the
7 Channel DMX Mode.
• To run the 8 Channel Mode, press the MODE button until "Ch08" is displayed. This is the
8 Channel DMX Mode.
• To run the 11 Channel Mode, press the MODE button until "Ch11" is displayed. This is the
11 Channel DMX Mode.
• To run the 12 Channel Mode, press the MODE button until "Ch12" is displayed. This is the
12 Channel DMX Mode.
3. Please see pages 15-22 for DMX values and traits.
4. After you have chosen your desired DMX Channel mode plug in the fixture via the XLR connections
to any standard DMX controller.
RGBWA + UV Dimmer Mode:
1. Plug the fixture in and press the MODE button until "r.XXX" is displayed. You are in Red dimming
mode.
2. Press the UP and DOWN buttons to adjust intensity. After you have finished adjusting the
intensity, or if you would like to skip to the next color, press the SET UP button.
3. When "G.XXX" is displayed you are in Green dimming mode. Press the UP and DOWN buttons to
adjust intensity.
4. When "b.XXX" is displayed you are in Blue dimming mode. Press the UP and DOWN buttons to
adjust intensity.
5. When "U.XXX" is displayed you are in White dimming mode. Press the UP and DOWN buttons to
adjust intensity.
6. When "A.XXX" is displayed you are in Amber dimming mode. Press the UP and DOWN buttons to
adjust intensity.
7. When "u.XXX" is displayed you are in UV dimming mode. Press the UP and DOWN buttons to
adjust intensity.
8. After you have adjusted the colors to make your desired color you can then activate strobing by
pressing the SET UP button to enter the strobe mode.
9. "FSXX" will be displayed, this is strobe mode. The strobe can be adjusted between "00" (flash
off) to "15" (fastest flash).
ADJ Products, LLC - www.adj.com - Mega HEX Par User Manual Page 10
Operating Instructions