Symmetricom TimeSource 3100 User Manual page 114

Chapter 4 TL1 Reference
Commands
Aid Parameter
TS3100 ROFREQ=a
TOD=a
ALMCOND=a
IPNE=a.b.c.d
(See Note 1)
IPSUBNET=a.b.c.d
(See Note 1)
IPGATE=a.b.c.d
(See Note 1)
114 TimeSource User's Guide
Value
a=5 or 10 Frequency for both remote oscillator inputs
in MHz
a=CISCO Serial TOD message sent in CISCO format
a=NTP4 Serial TOD message sent in NTP4 format
a=NONE No serial message sent
a=ALW Alarm conditioning for E1, TOD, and IRIG-B
outputs is enabled
a=INH Alarm conditioning for E1, TOD, and IRIG-B,
outputs is disabled
a = 0 to 255 IP address of this TimeSource 3100
(command must be sent from COM1,
b = 0 to 255 COM2, or Craft port to set this parameter)
c = 0 to 255
d = 0 to 255
a = 0 to 255 Subnet mask for this TimeSource 3100
(command must be sent from COM1,
b = 0 to 255 COM2, or Craft port to set this parameter)
c = 0 to 255
d = 0 to 255
a = 0 to 255 Default gateway IP address for this
TimeSource 3100 (command must be sent
b = 0 to 255 from COM1, COM2, or Craft port to set this
parameter)
c = 0 to 255
d = 0 to 255
Description
097-72020-01 Revision K – December 2005