Coolant/Hot Water Heater Fluid - Mitsubishi i-MiEV 2011 Owner's Manual

Coolant/Hot water heater fluid

E08402100019
To check the coolant level
Coolant
1. Open the tailgate.
2. Peel off the Velcro fastener (A) to remove
the luggage floor carpet (B).
NOTE
l A heat insulating material is attached to the
luggage floor carpet. To remove the luggage
floor carpet, grab and lift up both the carpet
fabric and the heat insulating material.
3. Turn the 4 screws on the front and rear of the
electric motor unit room lid (C) anticlock-
wise to loosen and remove them, and then re-
move the electric motor unit room lid (C).
NOTE
l When laying the electric motor unit room lid
on the ground, leave the underside of the lid
with the rubber surface facing up. If the un-
derside is facing downward rubbish and oth-
er foreign material could get on the rubber
surface and prevent proper reinstallation of
the electric motor unit room lid.
4. Check the coolant level in the reservoir tank
(D).
Vehicle care and Maintenance
While the motor is cold, the coolant level
must always be between the "FULL" and
"LOW" marks.
FULL
LOW
5. Refit the electric motor unit room lid and the
luggage floor carpet by following the remov-
al procedures in reverse.
Hot water heater fluid
A transparent reserve tank (A) is located in the bon-
net room.
The coolant level in this tank should be kept be-
tween the "FULL" and "LOW" marks when meas-
ured while the electric motor is cold.
FULL
LOW
8
8-09