Mitsubishi i-MiEV 2011 Owner's Manual page 133

For emergencies
14. Place the compressor (N) with its air pres-
sure gauge (O) on top.
Pull out the compressor's power cord (P), in-
sert the plug on the cord into the accessory
socket (Q), and then turn the electric motor
switch to the "ACC" position.
Turn ON the compressor switch (R) and in-
flate the tyre to the specified pressure.
CAUTION
7
l
The supplied compressor is designed only
for inflation of passenger vehicle tyres.
l
The compressor is designed to run on a ve-
hicle's 12 V power supply. Do not connect
it to any other power source.
l The compressor is not waterproof. If you
use it in rain, make sure water does not
get on it.
7-08
CAUTION
l
Any sand or dust sucked into the compres-
sor could make the compressor break
down. Do not place the compressor direct-
ly on any sandy or dusty surface when us-
ing it.
l Do not disassemble or modify the com-
pressor. Also, do not subject the air pres-
sure gauge to shock. It could malfunction.
15. Check and adjust the tyre pressure with refer-
ence to the air pressure gauge on the compres-
sor. If you overinflate the tyre, release air by
loosening the hose's end fitting. (Refer to
"Tyre inflation pressures" on page 8-15.)
If there is a gap between the tyre and wheel
because the tyre has moved inward from the
wheel rim, press the periphery of the tyre to-
wards the wheel to close the gap before run-
ning the compressor. (With no gaps, the tyre
pressure will rise.)
CAUTION
l
Be careful not to get your fingers trapped
between the tyre and wheel as the tyre in-
flates.
l The surface of the compressor will get
hot while the compressor is running. Do
not keep the compressor running continu-
ously for more than 10 minutes. After us-
ing the compressor, wait for the compres-
sor to cool before using it again.
CAUTION
l
If the compressor becomes sluggish or
hot while operating, it is overheating. Im-
mediately place the switch in the OFF po-
sition and let the compressor cool down
for at least 30 minutes.
NOTE
l If the tyre pressure does not rise to the speci-
fied level within 10 minutes, the tyre may be
so severely damaged that the tyre sealant can-
not be used to effect an emergency repair.
Please contact a MITSUBISHI MOTORS Au-
thorized Service Point or another specialist
in this event.
16. Turn OFF the compressor switch, then pull
the power cord plug out of the socket.
NOTE
l
Simply putting sealant and air into the tyre us-
ing the tyre repair kit does not seal the punc-
ture hole. Air will leak through the puncture
hole until the emergency repair procedure is
completed (through step 19 of these instruc-
tions).
17. When you have inflated the tyre to the speci-
fied pressure, stow the compressor, bottle,
and other items in the vehicle and promptly
start driving the vehicle so that the tyre seal-
ant can spread evenly in the tyre. Drive with
great care. Do not exceed a speed of 80 km/h
(50 mph). Observe local speed limits.