Table of Contents
Advertisement
Preface
Compliance
FCC Part 68 Compliance
Connection of data communications equipment to the public telephone network is regulated by
FCC Rules and Regulations. This equipment complies with Part 68 of these regulations which
require all of the following:
For single or multi-line equipment that connects to the telephone network via a plug and jack, the
plug and jack must comply with the FCC Part 68 rules. This device is designed to be connected to
the telephone or premises wiring, using a compatible modular jack which is Part 68 compliant.
The telephone company may discontinue your service if the unit causes harm to the telephone
network. If possible, you will be notified of such an action in advance. If advance notice is not
practical, you will be notified as soon as possible and will be advised of your right to file a complaint
with the FCC. The telephone company may change its communication facilities, equipment,
operations and procedures where reasonably required for operation. If so, the telephone company
will notify you in writing. All repairs or modifications to the equipment must be performed by
General DataComm. Any other repair or modification by a user voids the FCC registration and the
warranty.
To connect the product to the Public Telephone Network, you are required to give the following
information to the telephone company:
•
FCC Registration Number: US:AG6DENAN97J
•
Telephone Company jack type: RJ48C, RJ11C
•
Facility Interface Codes: DDS - 04DU9-DN/BN/1KN/1SN, 02LS2
•
Service Order Code: DDS- 6.0Y, 9.0Y
Industry Canada Notification
The Industry Canada label identifies certified equipment. This certification means that the
equipment meets telecommunications network protective, operation and safety requirements as
prescribed in the appropriate Terminal Equipment Technical Requirements document(s). The
Department does not guarantee the equipment will operate to the user's satisfaction.
Before installing this equipment, users should ensure that it is permissible to be connected to the
facilities of the local telecommunications company. The equipment must also be installed using an
acceptable method of connection. The customer should be aware that compliance with the above
conditions may not prevent degradation of service in some situations.
Repairs to certified equipment should be coordinated by a representative designated by the supplier.
Any repairs or alterations made by the user to this equipment, or equipment malfunctions, may give
the telecommunications company cause to request the user to disconnect the equipment.
Users should ensure for their own protection that the electrical ground connections of the power
utility, telephone lines and internal metallic water pipe system, if present, are connected together.
This precaution may be particularly important in rural areas.
Caution: Users should not attempt to make such connections themselves, but should contact the
appropriate electric inspection authority, or electrician, as appropriate.
076R200-000
Issue 2
SpectraComm IP Router Card
Installation and Operation Manual
Compliance
vii
Advertisement
Table of Contents
