Table of Contents
Advertisement
SC-IP Configuration
•
Commands entered with the proper syntax and all required parameters and arguments will take
affect immediately. If required parameters or arguments are missing from the command string,
you will be prompted for them individually.
•
Abbreviated commands are accepted at the command prompt.
•
For information on configuring IP and subnet mask addresses, refer to
Appendix A, Application Guidelines
Initializing the SC-IP for Configuration
1. Ensure your workstation is equipped with communication software (i.e., Hyperterminal) for
making a VT-100 connection. Consult your PC's operating system documentation for details.
2. For initial configuration of a SC-IP, you must configure a VT100-compatible terminal for the
following settings:
3. Connect the terminal to the SC-IP CRAFT (console) port using the provided cable:
(GDC P/N 029H211-001).
4. Make a Hyperterminal connection to the CRAFT port.
5. Hit <CR> a few times or press CTRL-R. The following login screen will appear, followed by
a command line prompt:
***************************************************************************
***************************************************************************
**
**
**
**
**
**
**
**
***************************************************************************
***************************************************************************
SC-IP>
Note
For online help screens describing all CLI options, press
SC-IP are only available when you have enabled supervisor privileges or the higher admin privileges.
6. Enable supervisor privileges by typing enable <cr>.
When prompted for the password, type:
supervisor <cr>
7. The SC-IP is now operating in supervisor mode as shown by the # symbol in the new CLI
prompt, with all CLI options available.
8. You can now configure the SC-IP to suit your network by typing the required configurations
commands at the CLI prompt. You do not need to set parameters that coincide with system
defaults. Any configuration changes will take affect immediately.
Note
FOR ADVANCED USERS: The SC-IP provides a utility for generating the configuration settings of a SC-IP
into an ASCII file, simplifying the configuration of multiple SC-IPs. This function can also be used to archive
configuration data for specific unit or as a baseline for modified configurations.
Refer to
Appendix A, Application Guidelines
3-2
.
N,1
9600,8,
W E L C O M E
T O
S P E C T R A C O M M
Copyright General DataComm 2002
Running version is T0.0.18
Use "?" at any time on the command line to get help.
[default supervisor password]
:
SpectraComm IP Router Card
Installation and Operation Manual
Initializing the SC-IP for Configuration
I P
?
Note that the CLI options for configuring the
Batch Up/Download Overview
**
**
**
**
**
**
**
**
.
076R200-000
Issue 2
Advertisement
Table of Contents
