Table of Contents
Advertisement
Preface
Precautions
The CAUTION, WARNING, and DANGER statements that appear throughout this manual are
intended to provide critical information for the safety of both the service engineer and operator, and
enhance equipment reliability. The definitions and symbols for such statements comply with ANSI
Z535.2, American National Standard for Environmental and Facility Safety Signs, and ANSI
Z535.4, Product Safety Signs and Labels, issued by the American National Standards Institute.
CAUTION
minor to moderate injury. It may also be used to alert against unsafe practices.
WARNING
in death or serious injury.
DANGER
death or serious injury.
Safety Guidelines
Under proper conditions, this unit will operate reliably and safely in your network. If any
component is improperly handled or installed, equipment failure or personnel hazard may occur.
Use caution and common sense when installing network wires. Use the following guidelines,
especially when unsafe conditions exist or when potentially hazardous voltages are present:
•
Repairs must be performed by qualified service personnel only.
•
To reduce the risk of electrical shock, do not operate equipment with the cover removed.
•
Never install network jacks in a wet location unless the jack is designed for that location.
•
Never touch uninsulated network wires or terminals unless the network line is disconnected
at the network interface.
•
Never install network wiring during an electrical storm.
Antistatic Precautions
Electrostatic discharge (ESD) results from the buildup of static electricity and can cause computer
components to fail. ESD occurs when a person whose body contains a static buildup touches a
computer component. The SC-IP card may contain static-sensitive devices that are easily damaged.
Proper handling, grounding and precautionary ESD measures are essential. Keep parts and cards in
antistatic packaging during transport or when not in use. When handling always use antistatic
floorpads, workbenchpads and an antistatic wrist strap connected to a grounded equipment frame
or chassis. If a wrist strap is not available, periodically touch an unpainted metal surface on the
equipment. Never use a conductive tool, like a screw driver or paper clip to set switches.
vi
Indicates a potentially hazardous situation which, if not avoided, may result in
indicates an imminently hazardous situation which, if not avoided, could result
indicates an imminently hazardous situation which, if not avoided, will result in
SpectraComm IP Router Card
Installation and Operation Manual
076R200-000
Issue 2
Advertisement
Table of Contents
