Table of Contents
Advertisement
The Web Interface
IP Static Route Web Screen
The IP Static Route Configuration screen displays a read-only list all entered destination devices or
networks and their static routing attributes. Information displayed on this is compiled from data
entered at the command line interface or derived from the IP address and mask. For more
information, refer to Chapter 3:
provided at the Command Line web screen.
Table 4-6
IP Route Configuration Screen
Field
IP Address/
Prefix
Next Hop/GW
Metric
Interface
Line Protocol
Type
4-8
Configuring SC-IP with Smart CLI
Displays the IP address configured for destination devices, networks or interfaces.
Displays the configured IP address of the next hop or gateway address that must be used
to forward the packet out the corresponding 'interface.'
Displays the value (0-255) used by the router to determine the 'cost' of using the route. If
a destination can be reached by two or more routes, the one with the lowest cost is used.
Specifies which logical port will be used to forward the received IP packet:
ethernet0 (LAN port),
serial0 (T1port) or serial0. nnn (DLCI nnn on T1 port)
serial1 (synchronous DTE port) or serial1. nnn (DLCI nnn on T1 port)
modem0 (modem port)
Displays the Layer 2 protocol for the interface (UP or DOWN).
Displays the type of route.
SpectraComm IP Router Card
Installation and Operation Manual
SC-IP Web Screens
, or use the CLI online help
Description
076R200-000
Issue 2
Advertisement
Table of Contents
