Table of Contents
Advertisement
SC-IP Configuration
Configuring SC-IP with Smart CLI
The following paragraphs describe the basic procedures for accessing and configuring SC-IP using
the command line interface (CLI). After setting up user accounts, select the configuration procedure
best suited to your network environment:
•
SC-IP as a IP router for a Frame Relay network
(For static Frame Relay network applications)
•
SC-IP as an IP router for Leased Line (PPP) T1 network
(For static PPP multi-point network applications)
•
SC-IP as a LAN-extension device
(For "flat" IP network applications - no routing)
Access to SC-IP Command Line Interface (CLI)
SC-IP controls access to the CLI through its three access modes: USER, SUPERVISOR and
ADMIN. The password-protected enable command sets the access from user mode to
supervisor or admin mode, depending on the password entered. The command prompt suffix
character identifies the mode you are currently in:
•
For USER mode, the prompt string ends in >
Commands in USER mode allow viewing but not changing configuration data.
•
For SUPERVISOR mode, the prompt string ends in #
Commands in SUPERVISOR mode allow USER access plus the ability to change
configuration data, reboot the unit, manipulate flash files and enable the TFTP server for file
downloads.
•
For ADMIN mode, the prompt string ends in %
Commands in ADMIN mode allow SUPERVISOR access plus the ability to set up and modify
user accounts for usernames and passwords. ADMIN mode also allows authentication for the
CRAFT port to be turned on or off.
Note
Up to 20 usernames/passwords may be specified. The Default Username is
Password is
gdc
Setting Up User Accounts
1. Type disable to turn off the supervisor access.
2. Turn Admin mode on by typing enable and entering the admin password. The command
prompt will now contain the % character.
3. Modify default admin and supervisor accounts by typing:
configure accounts add admin
configure accounts add supervisor
4. Add a user account and password by typing:
configure accounts add
076R200-000
Issue 2
; Supervisor mode password is
[name] [password]
SpectraComm IP Router Card
Installation and Operation Manual
Configuring SC-IP with Smart CLI
gdc
supervisor
; Admin mode password is
[new admin password]
[new suprv password]
; In User mode, the Default
admin
.
3-3
Advertisement
Table of Contents
