Table of Contents
Advertisement
Introduction and Specifications
The SC-IP Front Panel
Table 1-1
describes the front panel connectors and indicators on the SC-IP Router card.
Figure 2-1
describes the SC-IP rear panel as deployed in a SpectraComm shelf or enclosure system.
Physical features that support DDS and Modem facilities are implemented in a future release.
Table 1-1
SC-IP Card Front Panel
SC-IP Front Panel
LEDs / Ports
ON
INS
MODEM TX
-Future Use-
INS
ON
MODEM RX
-Future Use-
MODEM
T1 TX
T
R
E1
X
X
AUX
T1 RX
C
AUX TX
R
A
-Future Use-
F
T
AUX RX
TM ALM
-Future Use-
P
ALM
O
R
-Future Use-
T
TM
1
ETHERNET
-Future Use-
1
2
P
Craft Port
O
R
T
Ethernet Port 1
2
Ethernet Port 2
Ethernet LEDs
(1 and 2)
SC-IP E1
1-6
Description
Action
On (GREEN) indicates SC-IP is receiving power.
On (GREEN) indicates SC-IP is ready for operation.
Off
No send data present at the Modem port.
On (GREEN)
Indicates Send Data frames are present at the Modem port.
Off
No Receive Data present at the Modem port.
On (GREEN)
Indicates the presence of data frames at the Modem port,
received from the remote modem.
Off
No data is being sent out at T1 Network port.
On (GREEN)
Indicates Send Data frames are present at the T1 Network
port.
Off
No Receive Data present at the T1 Network port.
On (GREEN)
Indicates data present at the T1 port, originating from the
Network.
Off
No send data present at the AUX port.
On (GREEN)
Indicates Send Data frames are present at the AUX port.
Off
No Receive Data present at the AUX port.
On (GREEN)
Indicates Receive Data frames present at the AUX port.
Off
Normal conditions.
On (RED)
Indicates T1 Network alarm (AIS, RAI, or LAD).
Off
Indicates normal operating conditions.
On (RED)
Indicates SC-IP is in Test Mode, performing a diagnostic test.
RS-561-compatible jack for direct connection of the unit to a local
VT100-compatible ASCII terminal.
Each Ethernet port supports
10/100Base-T connectivity.
Off
Ethernet port 1 or 2 is not connected
On (STEADY)
Steady On (GREEN) indicates the Ethernet port (1 or 2) is
connected and not passing data.
ON (BLINKING) Blinking On (GREEN) indicates the Ethernet port (1 or 2) is
connected and actively passing data.
SpectraComm IP Router Card
Installation and Operation Manual
The SC-IP Front Panel
076R200-000
Issue 2
Advertisement
Table of Contents
